EBKA SoftHeat Thermostat
INSTALLATION INSTRUCTIONS
FOR EBHA SOFTHEAT BASEBOARD
Description
The EBKA-1-24 end cap thermostat kit is an accessory
for the EBHA Series of hydronic baseboard heaters.
This kit will provide thermostatic control of the heater
in place of a wall mounted thermostat.
Note: The EBKA-1-24 end cap thermostat can only
be installed on the left end of heater. It is designed
e
to control only one EBHA heater unit.
Tools Required: Phillips Screwdriver, Insulated Wire
®
Connectors (Wire Nuts ), Strain relief connector
FIGURE 1: Thermostat kit assembly
EBKA
Thermostat
EBHA Heater
Junction box cover
IMPORTANT INSTRUCTIONS
If you are uncomfortable working with electrical appliances, unable to follow these guidelines,
or do not have the necessary equipment; consult a licensed electrician.
WARNING
Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock
or tag the panel board door to prevent someone from turning on power while you are working on
the heater. Failure to do so could result in serious electrical shock, burns, or possible death.
SAVE THESE INSTRUCTIONS
TEL: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
|
Black Decker Saw 611763 00 User Manual
Blanco Indoor Furnishings M1011 06 User Manual
Bogen Stereo Amplifier 600 ohm User Manual
Bradford White Corp Water Heater Solar Water Heater with Electric Backup User Manual
Brother Scanner ADS2500W User Manual
Candy Washer GOFS User Manual
Canon Camera Lens MX439 User Manual
Carrier Refrigerator 1300L User Manual
Casio Digital Camera EX Z120 User Manual
Changhong Electric Flat Panel Television LT2618, LT3218, LT3718, LT4018 User Manual